[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [oc] cloning of processors



Hi,

I want to read/write data from Hard disk into the host.
I am using IDE interface for this. Host is Coldfire.(Motorola Amadeus).
After I configured the processor for IDE. 

As per the standard of IDE, ATA-3  to read data from harddisk, I wrote 
the proper command into IDE command register after proper 
configuration.
IDE should send interrupt to host when data becomes ready.
Now PROBLEM for me is IDE is not sending any interrupt. But data on IDE 
side is getting ready. If I read data on IDE side after certain time, data 
whatever I am reading into host from IDE is correct.

But I want to read after interrupt comes only as I don't want to waste 
my processor time by pending on interrupt. 
Can anyone answer this what should I do to get interrupt from IDE??

regards
Mallika


----- Original Message ----- 
From: Mark Bonnici <mbonnici@r... > 
To: <cores@o... > 
Date: Fri, 10 Aug 2001 14:48:30 +0200 
Subject: [oc] cloning of processors 

> 
> 
> Hello all 
> 
>    i think that cloning of processors should be possible. 
> Now we are moving towards cloning verything (even persons) 
> -so why should we not clone digital processors from documentation 
> which is freely available? 
> 
> Mark 
> -- 
> 
--
To unsubscribe from cores mailing list please visit http://www.opencores.org/mailinglists.shtml