From: J.Vieira (vieirant@terra.com.br)
Date: Fri Dec 15 2000 - 04:10:31 CET
Hello small World of MuLinux
I get the same error "Symbol 'io' not found" trying to use my ne2k-pci on
mu10r5
I´ve already seem this film!!!
Jose Vieira
Linux User 100.600
-----Mensagem original-----
De: Jos? Luis G?mez Dans
[mailto:jgomez@faust.champagne.sp.inova.com.br]Em nome de José Luis
Gómez Dans
Enviada em: quinta-feira, 14 de dezembro de 2000 15:15
Para: mulinux@sunsite.auc.dk
Assunto: Re: mu SETUP
On Thu, Dec 14, 2000 at 07:06:40PM +0100, Christian Bourgeois wrote:
> > If I well remember, it is based on a rtl8139 chip, so it should work
with
> > rtl8139 netword module.
Note that this is a PCI card...
> > But,
> >
> > when "setup eth0 CARD=rtl8139 IRQ=5 IO=0xE000 IP=192.168.0.203" i always
> > get the error "Symbol 'io' not found" !!!
> > I haven't figured out where the problem comes from.
> >
> > Before installing mulinux on the computer, I had tested it
> > with floppy disks (with SRV only, not WKS), and it worked fine with that
> > card. But is was not the last version, it was the 11r1 I think.
There's no IO or IRQ for a PCI card. If you just do
insmod rtl8139, you would be alright. I don't have mu at hand, but you
don't what to have any IO or IRQ for thsi card
> > I tested the above hard disk installation with the 10r5 and 11r2, and
both
> > give the same error.
> >
>
> Do you have any idea ?
> It'll be very helpfull, as I'm going to install it on about 25 computers
!!!
>
> Also, is there any way to protect the "C:\LINUX" from being modified when
in
> DOS mode ?
>
> Thanks a lot,
>
> Cheers,
> Christian.
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk
> For additional commands, e-mail: mulinux-help@sunsite.auc.dk
-- José L Gómez Dans PhD student Tel: +44 114 222 5582 Radar & Communications Group FAX; +44 870 132 2990 Department of Electronic Engineering University of Sheffield UK --------------------------------------------------------------------- To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk For additional commands, e-mail: mulinux-help@sunsite.auc.dk --------------------------------------------------------------------- To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.auc.dk For additional commands, e-mail: mulinux-help@sunsite.auc.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:17 CET