NAME
    Linux::NBD::Client - client (device) side of a network block device

SYNOPSIS
     use Linux::NBD::Client;

DESCRIPTION
    WARNING: I talked to the author of the nbd driver because nbd is so
    extremely racy (right now, stopping it often causes oopses, a server
    crashing also often oopses etc..).

    It turned out that he doesn't care at all and nbd is basically
    unmaintained, so YMMV when using this module, especially when writing
    servers.

    He really should have said that on his nbd pages ;[.

    OTOH, it works relatively reliable when you don't stop the servers, so
    watch out and keep your fingers crossed.

METHODS
    $client = new Linux::NBD::Client [socket => $fh][, device =>
    "/dev/ndx"], ...
        Create a new client.

        Unless "device" is given, an unused device node is looked up using
        the "device" method (this might result in an exception!).

        The other arguments correspond to calls to methods of the same name.

    $client->socket([$tcp_socket])
        Returns the current socket after setting a new one (if an argument
        is supplied). The socket *MUST* be a tcp socket. Believe, bad things
        will happen.

        The special argument "undef" will try to clear the socket, if any
        was set.

    $client->device([$new_device])
        Returns the current device node (e.g. "/dev/nd2") after setting a
        new one if an argument is supplied.

        If the argument is "undef" it will search for an unallocated
        nbd-device and use it.

    $client->disconnect
        Tries to exit the server by ending a special disconnect message.

    $client->clear_queue
        Clears the request queue, if possible. Should be used before setting
        a new socket.

    $client->set_blocksize($blksize)
        Set the device blocksize in bytes (must be >512, <PAGESIZE and a
        power of two).

    $client->set_size($bytes)
        Set the device size in bytes.

    $client->set_blocks($nblocks)
        Set the size in blocks.

    $client->run
        Enters the service loop (waits for read/write requests on the device
        and forwards them over the given socket). Only returns when somebody
        calls "disconnect" or the server is killed.

    $pid = $client->run_async
        Runs the service loop asynchronously and returns the pid of the
        newly created service process.

    $client->kill_async
        Kills any running async service. Please note that this also kills
        the socket, so you need to re-set the socket after this call.

AUTHOR
     Marc Lehmann <schmorp@schmorp.de>
     http://home.schmorp.de/