[oc] VHDL uart(9600,8,N,1) help. urgent

[ckh827@hotmail.com]

I'm currently working on the Vhdl for Xilinx's FPGA.  The output is 
characters which will be sent to RS232 port.  The chip's frequency is
11.05 Mhz. Since it's (9600,8,N,1),  I tried to use a counter that
count to 1151(11.05MHz/9600 = 1151) and then output a 'high' in order
to generate 9600 baud rate.  However, what I got is always junks.
In vhdl, I use Wait on clk9600 = '1' to send one bit at a time and I
used for ten times because its total is ten bits(start +data+ stop
bit). Is this the correct way to do this? And also, there are only
(transmit,receive and ground pins going through rs232 com1 port)

I need some help as soon as possible.  Any help is appreciated.

Could anybody give me some suggestions to code this program.
--
To unsubscribe from cores mailing list please visit http://www.opencores.org/mailinglists.shtml