NPC Configuration
Broadcast
1. Click on the "Notification Process Center Setting"
tab and Broadcast to display Broadcast settings.
2. Fill in or select the following configuration fields:
Enabled:
Select this check box to enable the notification.
3. Click Apply or OK to proceed with configuration.
Note that configuration will be saved to the reserved space on the array and
may cause a short delay.
4. Click Broadcasting List from the tabbed panel above.
Host IP: The IP address a broadcast message will be sent to.
Severity: Select the severity level of events to be sent to
the receiver station.
Computers receiving broadcast messages will be added to the list on the right.
5. Click Apply or OK to complete the configuration.
Back to Help Contents