From: R.E. Berling (Rebco@CCRTC.Com)
Date: Sat Sep 08 2001 - 16:46:48 CEST
Michele:
The reason I loaded it manually was because I could not get it to load using
the eth0 setup. The problem was due to supplying the io and irq at
(setup -f eth0). After configuring it again using blank ("") for io and
irq, it loaded as it should.
Why didn't I try that the last 50+ attempts? I do not know.
I'm sure you spend a lot of time working on mu and answering questions such
as this. Thanks for your time and prompt reply.
reb
----- Original Message -----
From: Michele Andreoli <m.andreoli@tin.it>
To: <mulinux@sunsite.dk>
Sent: Saturday, September 08, 2001 3:11 AM
Subject: Re: mu SETUP
> On Fri, Sep 07, 2001 at 08:52:27PM -0400, R.E. Berling nicely wrote:
> > Trying to load module eepro100 for eth0 to automatically setup the NIC
at startup.
> > setup -m eepro100 or net/eepro100
> > Setup eth0
> > setup -s <profile>
> > Startup messages indicate that the NIC "is not well configured" and
therefore does not load.
> >
> > After getting to the root prompt I can "insmod" eepro100 and "Setup"
eth0. Then NIC works as expected.
> >
> > Any ideas what I'm doing wrong?
> >
>
> Why you did load manually the driver with "setup -m"?
> Please, follow each question in the interactive panel
>
> # setup -f eth0
>
> the save the profile. This will works, if driver is ok.
>
> Michele
>
> --
> I keep trying to locate a meeting of Quantum Physicists. But everytime
> they set a meeting time, the location changes. And vice versa -- Anonymous
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.dk
> For additional commands, e-mail: mulinux-help@sunsite.dk
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: mulinux-unsubscribe@sunsite.dk
For additional commands, e-mail: mulinux-help@sunsite.dk
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:19 CET